Home Wire Drawing Machine Accessory Machine Layout Show Case Spare Parts Quotation Calculator On Line Calculator On Line Contact Us

Accessory Machine

Annealing Furnace

  • Anealing Furnace

  • Cleaning Before Anealling

  • Cooling Bath After Anealling

  • Anealing Furnace

  • Cleaning Before Anealling

  • Cooling Bath After Anealling

This kind of annealing furnace is the continuous type, it can anneal the low carbon wire, the stainless steel wire after drawn directly, don't need to coil the wire to anneal. It can save the operate time and easy to control and operate.
1) For the continuous anneal line, there are 20 pipes, and the annealing furnace tube is 33
2) Annealing temperature: 800-900℃
3) Annealing speed: 15m/min
4) The outside dimension L8000XW2030XH1720 (the distance from furnace tube to ground middle is 1000mm)
5) Inside structure: inside is firebrick, middle-side is high temperature resistant wool board, outside is transported brick, outermost layer is high temperature wool board, the width of furnace chamber is 1130mm ,height of chamber is 200mm .
6) Rated voltage: main furnace 25KWX6 groups, 6 districts temperature control
7) To heat the heating wire use top-heat mode, material is OCr21AL6Nb, the top of furnace adopts folding chunking warm-keep material.
8) Temperature control instrument use PID to adjust, temperature measurement element use 6 pieces platinum-rhodium-platinum alloy thermoelectric couple temperature control +/-2 degree
9) Temperature control executing element is high power controllable thyristors modules, by adjusting current to control the temperature, the precision is high. The main wire from control box to anneal furnace offered by the buyer.
10) Furnace tube is 2520si material dia. 33x3x 83000mm
11) Temperature of outside of furnace is less than room temperature+40 degree